Car steering Mercedes Vito 2 (W639)

Hydraulic power steering (GUR
A rotary vane hydraulic pump is used to pump oil into the hydraulic cylinder (such pumps are also called vane pumps). An eccentrically mounted rotor is located in the...

Steering column
VN 6.005 1. Steering column cover; 2. Steering column lock; 3. Steering column lock rod; 4. Nut; 5. Bolt; 6. Bolt

Steering wheel
The steering wheel is attached to the steering shaft with a central screw. A number of control keys are installed on the steering wheel, to which connecting wires are...

Removal and installation of a steering wheel
1. Turn the steering wheel to the center position. 2. Loosen the central screw (1) 3. Remove the steering wheel. 4. Install in reverse order. VN 6.007 1. Central screw

Removing the rotating contact joint
1. Remove the steering wheel. 2. Remove the outer casing of the steering column (1) (pic. VN 6.008). 3. Loosen the fixing screws. 4. Remove the inner lining of the...

Setting the middle position of the rotating contact joint (VKS)
The VKS is adjusted as follows. Turn the housing of the VKS counterclockwise until it stops (don't put in too much effort!) - Then turn the VKS case clockwise by 3-3.5...

Removal and installation of the steering wheel angle sensor
1. Remove the rotating contact joint (further - VKS). 2. Remove the steering angle sensor (B24/8), by pulling it up. 3. Disconnect the steering wheel angle sensor...

Removal and installation of a tip of steering draft
1. Loosen the locknut (4). 2. Loosen the inner (3) and external (1) duster clamps. 3. Remove the tie rod boot (2). 4, Install in reverse order. VN 6.012 1. External...

Removal and installation of steering draft
VN 6.013 1. Tie rod; 2. Steering rack

Gear gap adjustment in rack and pinion
To adjust the gear gap, proceed as follows. Tighten the adjusting screw (1) torque 55-60 Nm, after tightening, turn the adjusting screw (1) counterclockwise 1/8 turn. VN...