2.0L petrol engine cooling system Mercedes Vito 1

Fan — removal and installation
Removing 1. Disconnect the negative cable from the battery. 2. Remove the top cross beam. 3. Push radiator 1 forward (in the direction of travel) (see fig. 2.98). Pic....

Radiator — removal and installation
Removing 1. Disconnect the negative cable from the battery. 2. Drain the coolant. 3. Empty the air conditioning system. 4. Remove grille 2 (see fig.2.99). Pic. 2.99....

Coolant pump
Removing 1. Drain the coolant. 2. Disconnect the negative cable from the battery. 3. Remove the air filter housing. 4. Remove the crankshaft groove pulley. 5. Disconnect...

Thermostat — removal and installation
Removing 1. Remove the air filter. 2. Drain the coolant. 3. Detach the strap (arrow) from lifting eye 8 (see fig.2.104). Pic. 2.104. Thermostat: 1. Bolt, 2. Tube from...

Oil radiator
Removing 1. Remove the air filter. 2. Drain the coolant. 3. Remove support bar 6 and fasten it to the side (see fig.2.105). Pic. 2.105/Oil cooler: 1. Branch pipe to the...

Coolant temperature sensors
Removing 1. Disconnect the negative cable from the battery. 2. Reduce the pressure in the cooling system by opening the cap on the expansion tank. 3. Disconnect...

Air conditioner condenser
Removing 1. Empty the air conditioning system. 2. Remove the cross beam. 3. Remove the grille. 4. Remove screw 5 (see fig. 2.108). Pic. 2.108. Air conditioner condenser:...

Coolant level sensor
Removing 1. Turn off the ignition. 2. Drain the coolant. 3. Remove the upper transverse beam 1 (see fig.2.109). Pic. 2.109. Coolant level sensor: 1. Upper cross beam, 2....

Fan thermal switch
Removing 1. Disconnect the negative cable from the battery. 2. Drain the coolant. 3. Disconnect the wiring connector M34b20.1 from the thermal switch M34b20 (see...