Installation details of diesel engine glow plugs
1. Start the engine and warm it up to normal operating temperature (about 80°С).
Attention! Spark plugs should only be turned out after the cylinder head has completely warmed up!
2. Stop the engine.
3. Disconnect from a fuel distributive highway going to TNVD a returnable fuel line.
4. Disconnect the wiring (3) (see Section Checking glow plugs) and with a special tool (HAZET 4760-1) turn out the candles (R9).
5. Installation is carried out in the reverse order - do not forget to pre-clean the candle niches with a special perlon brush with a diameter of 10 or 6 mm.
6. Finally, start the engine and check the power system for signs of leaks.