Attention! At installation it is necessary to use new nuts of fastening of a connecting earring of the anti-roll bar of a back suspension bracket.
Removing
1. Raise the rear of the car and secure it on stands. Remove the corresponding rear wheel.
2. Unscrew the screws and remove the protective cover from the base of the lower rear suspension arm.
3. Unscrew the nut securing the connecting earring to the anti-roll bar.
4. Unscrew the nut and remove the nut that secures the connecting earring to the lower rear suspension arm, and remove the earring. Check the condition of the connecting shackle and, if necessary, replace it.
Installation
1. Install the connecting earring in place and insert the lower bolt of its fastening.
2. Install the upper part of the connecting eye on the anti-roll bar and screw on the new nut, tightening it to the required torque. Screw a new nut onto the bolt of the lower fastening of the connecting shackle and tighten it to the required torque.
3. Install the protective cover on the base of the lower arm and screw it on.
4. Install the wheel, then lower the vehicle to the ground and tighten the mounting bolts to the correct torque.